Hi there, I’m sorry and I bet this is something simple, but I’m stuck. I am trying to add an L298N with IN1, 2, 3, and 4 as BCM pins 17, 27, 22 and 23 respectively. I added the Output and saved this pin configuration - I did not specify any Enable pins, as my L298N breakout has those as permanent …

The current iteration of the Output requires the Enable Pin to be set. I can make the Enable Pin optional, but in the meantime, you can set it to a pin not in use and it should allow the output to function.

Thanks so much for the super-quick solution, I knew I’d seen you say this somewhere before but couldn’t find it. Supplying some idle pins solves my problem and I’m back up and running, thanks again!

You’re welcome. And since I happened to have my IDE open, I just added the option to disable the Enable Pin. This is untested, but should work. Let me know if you test it and there’s an issue. Make Enable Pin optional for L298N Output com…

Radical DIY Forum

L298N "output not set up"

Mycodo Mycodo Issue/Bug

output

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled