Hi there,
I have some PT1000 temperature probes with EZO RTD Circuits from Atlas Scientific.
I think that the temperature measured by my PT1000 is quite higher than the true water temperature.
I was wondering if by calibrating the probe via the commands of the ezo circuit, the calibration would be taken into account into mycodo ?
Mycodo only requests measurements from sensors. If the sensor incorporates any math or other functions in its calculation of the measurement value prior to it returning the value to Mycodo, then yes.
1 Like
I don’t know if this fits in here. if not move .a question about this is it possible to have multiple calibration points, for example 100c and 0c? because my sensor still shows wrong values after 100c calibration
The datasheet doesn’t mention anything other than a one-point calibration. I also added yesterday the ability to calibrate from the Input in Mycodo:
2 Likes