PID Controller date and time is stuck

Hi Kyle

Since upgrading to Mycodo 8.15.6 I have noticed that my PID controllers date and time is stuck on the 1/20 with the same time on all of them.
PID date
Even after I have re-installed the Mycodo it doesn’t fix it.

Many thx
Pieter

Try installing from the master branch rather than the last release. This could also be an issue with the system you’re installing Mycodo to rather than the software, however you’re not providing enough information to investigate with any significant depth.

Morning Kyle

The installation was done from scratch, I formatted the SD card and installed Raspberry Bullseye and then went onto Github and installed from the link copied to terminal. I have done this twice and the controllers doesn’t change. This also refers to my other post about the Daemon not running after the power gets up and running again. Daemon not running. Mycodo is installed on a Raspberry Pi 2B.

Many thx
Pieter

I’ve been able to replicate this behavior, so I’ll be looking into developing a fix.

This has been fixed and will be included in the next release.

Hi Kyle

Many thx for your effort to get it sorted. I will await the next release with anticipation.

Regards
Pieter