Where does the FAN operation set up in SETUP?

Mycodo
1

20220516085404
202205160854041023×582 307 KB

I connected the power control-4-channel ssr-RJ45 cable, and I connected the FAN to GPIO26 and set it on which menu in SETUP? For example, operate when the temperature is above 30 degrees and humidity is above 80 percent

2

The 3.3 volt signal from the GPIO switches the relay on and off. This can be set up on the Outputs page with the GPIO On/Off Output. Your fan will plug into the outlet controlled by the relay. Then you can control the fan from the Output in Mycodo.